This sturdy leather harness was designed for BBWs. It is recommended for measurements just below the waist ranging from 37" to 75". Each one is custom made after receiving your measurements. The only "fit restriction" that we have found for this harness is that the hips must be a larger measurement than the waist.

The belt is designed to go around the body just below the waist (this positioning will vary from woman to woman). One inch roller buckles on each side are used to adjust the size of the belt. We try to make the harness so that the buckles are initially set to the middle position of the holes.

The front panel snaps to the belt, and, can be set to 4 vertical positions. Then, the dildo "O" ring and other attachments can be snapped onto the front panel in a variety of "heights". This design also lets you change dildos without taking off the harness.

The front panel stops above the genitals, with the "rear straps" passing between the legs. This leaves the genitals uncovered and/or available for applying one of the attachments.

The "rear straps" pass between the legs and can lay over the buttocks in 3 different positions (see "Select" below). The ends of these rear straps attach to the back of the belt with 1" roller buckles, allowing you to snug up the straps and the front panel as much as you want.

Testimonials and more pics

Unusual uses: This harness can be used as a temporary chastity belt on either a male or female. Check out the attachments for some ideas. This harness can be worn by a male with a dildo attached to the front panel. Think of the possibilities with that!

Measure: To custom make this harness for you, we need *ALL* of the following 4 measurements (Example: #1:45 #2:8 #3:30 #4: 35) . The starting point for all of these measurements is at your waist and lined up with your bellybutton. Also, it may be helpful to have somebody else measure you.

1. Completely around the waist (typically between 38 and 72)
2. From the waist down to within an inch above the genitals (typically 6 to 10)
3. From the waist, down between the legs, straight up between the butt cheeks, and, to the waist at the spine. This measurement needs to be snug but not tight. (typically 28 to 40)
4. From the waist, down between the legs, diagonally up over the butt cheeks (like a jock strap), and, to the waist. This measurement needs to be snug but not tight. (typically 30 to 42, and, larger than #3)

Select: The rear straps attach to the belt with roller buckles in three different placements. These positions are related to measurements 3 and 4 above:

• Style A - a single roller buckle at the center of the back of the belt. The rear straps lay between the buttocks cheeks.
• Style B - two roller buckles positioned approximately 1/3 of the way from the spine around towards the bellybutton. The rear straps lay diagonally over the buttocks in the traditional "jock strap" style.
• Style C - two roller buckles positioned approximately 1/5 of the way from the spine around towards the bellybutton. The rear straps lay over the buttocks similar to the traditional "jock strap" style, but, not so far apart.
• Style D - combination of style A and style B. This allows the rear straps to lay between the buttocks cheeks *OR* to lay over the buttocks in the traditional "jock strap" style. Note: this style costs an additional $5.00. Simply add this separate item to your cart after selecting style A or B.

Note: attachments are NOT INCLUDED with the purchase of the harness. You must order the attachments separately.

Click here to see a version of this page that shows non-JavaScript big pics.